OSPF - Emulating an OSPF Router and

advertising Type-1 LSA's

Contents

Introduction
Prerequisites
     Requirements
     Components Used
OSPF Topology
Setting up SmartBits and enabling OSPF
Configuring OSPF parameters and establishing an adjacency
Advertising the Router ID (RID) as a Stub Network (Type-1 LSA)
Advertising the networks attached to the emulated OSPF router (Type-1 LSA)

Introduction

The purpose of this document is to provide the user step-by-step instructions to emulate a router
running OSPF and inject Type-1 and Type-2 LSA's to the Device Under Test (DUT)

Prerequisites

Requirements

The following HW/SW are required:

• SmartBits 600 or 6000 chassis with TeraMetrics module
• TeraRouting Tester (TRT) client application installed on workstation
• DUT - router supporting OSPF and configured to match the topology
  

Components Used

The following components were used:

• Router running OSPF (DUT)
  
• SmartBits 6000 chassis with TeraMetrics module
• TeraRouting Tester (TRT) version 4.50
  

OSPF Topology

Please configure the DUT to match the topology below

______________________________________

______________________________________

______________________________________

Advertising the networks attached to the emulated OSPF router (Type-1 LSA)