OSPF - Building a custom OSPF Topology
with the OSPF Topology
Editor
Contents
Introduction
Components Used
Configuration Summary
OSPF Topology
Setting up the SmartBits ports for OSPF
Using the Topology Editor to create the custom
OSPF network
Starting the OSPF routers and checking the
current state
Setting up traffic streams between OSPF networks
12-18
Interactively view graphs and counters
The purpose of this document is to provide the user step-by-step
instructions to setup
a custom OSPF network using TeraRouting Tester's Topology Editor
Components Used
- SmartBits 6000 chassis
- TeraRouting Tester (TRT) version 4.50
- TeraMetrics module with two available ports
- Router with two interfaces connected to SmartBits ports
Configuration
Summary
- Setup two SmartBits ports as OSPF adjacencies
- Simulate three OSPF routers on each SmartBits port
- Advertise the OSPF routers' loopback address via OSPF
- Send bi-directional traffic between the advertised LSA's
- Interactively measure and view packet counters
OSPF Topology
***
NOTE:
Before starting, please connect to the chassis. For help, click here ***
Setting up the SmartBits ports for
OSPF
_______________________
_______________________
_______________________
Using the OSPF Topology Editor to
create the custom OSPF network
_______________________
_______________________
_______________________
_______________________
Starting the OSPF routers and
checking the current state
_______________________
Setting up traffic streams between
OSPF networks
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
<>
_______________________
<>
_______________________
<>
_______________________
_______________________
| NOTE: For informational use only |
|